2pcs Hydros 0-5v PCB (For DIY)
Only intended for those with extensive electrical and soldering experience
This HarrysAquatics designed PCB allows users to generate 5 unique voltages from the 5v supply in the Control4 0-10v Input port, all on a single input channel. It is intended to be used for DIY switch boxes in conjunction with the HarrysAquatics 0-10v Breakout.
This incorporates a pulldown circuit (So the 0-10v channel will read around 0v instead of floating at 2.5v) as well as a resistor tree to enable the user to apply 1v, 2v, 3v, 4v, or 5v to the Control4. You can then use the Hydros app to program the appropriate response for each voltage.
This is NOT intended to power any external device, the purpose is solely to provide various analog outputs.
I am not responsible for any misuse of the PCB. Only use this if you have electrical knowledge and soldering experience. Of course NEVER short 5v and ground input rail together, or risk damaging the controller.
As a DIY item, no returns can be accepted after the user has soldered onto the PCB. These boards were tested by the manufacturer via Flying Probe after the SMD reflow process was complete.
NO SWITCH BOX INCLUDED! JUST BARE PCB!
Only intended for those with extensive electrical and soldering experience
This HarrysAquatics designed PCB allows users to generate 5 unique voltages from the 5v supply in the Control4 0-10v Input port, all on a single input channel. It is intended to be used for DIY switch boxes in conjunction with the HarrysAquatics 0-10v Breakout.
This incorporates a pulldown circuit (So the 0-10v channel will read around 0v instead of floating at 2.5v) as well as a resistor tree to enable the user to apply 1v, 2v, 3v, 4v, or 5v to the Control4. You can then use the Hydros app to program the appropriate response for each voltage.
This is NOT intended to power any external device, the purpose is solely to provide various analog outputs.
I am not responsible for any misuse of the PCB. Only use this if you have electrical knowledge and soldering experience. Of course NEVER short 5v and ground input rail together, or risk damaging the controller.
As a DIY item, no returns can be accepted after the user has soldered onto the PCB. These boards were tested by the manufacturer via Flying Probe after the SMD reflow process was complete.
NO SWITCH BOX INCLUDED! JUST BARE PCB!
Only intended for those with extensive electrical and soldering experience
This HarrysAquatics designed PCB allows users to generate 5 unique voltages from the 5v supply in the Control4 0-10v Input port, all on a single input channel. It is intended to be used for DIY switch boxes in conjunction with the HarrysAquatics 0-10v Breakout.
This incorporates a pulldown circuit (So the 0-10v channel will read around 0v instead of floating at 2.5v) as well as a resistor tree to enable the user to apply 1v, 2v, 3v, 4v, or 5v to the Control4. You can then use the Hydros app to program the appropriate response for each voltage.
This is NOT intended to power any external device, the purpose is solely to provide various analog outputs.
I am not responsible for any misuse of the PCB. Only use this if you have electrical knowledge and soldering experience. Of course NEVER short 5v and ground input rail together, or risk damaging the controller.
As a DIY item, no returns can be accepted after the user has soldered onto the PCB. These boards were tested by the manufacturer via Flying Probe after the SMD reflow process was complete.
NO SWITCH BOX INCLUDED! JUST BARE PCB!